PURLOGIC® PU foam cleaner Clean

PU foam cleaner PURLOGIC Clean

Art.-no. 089216

Prices for customers after login

PURLOGIC® PU foam cleaner Clean

Art.-no. 089216

Prices for customers after login



Show availability in Würth trade store

Exclusively for trade customers

Register now and access more than 125,000 products

Quickly and simply removes fresh PU foam residue

Highly effective solvent

Removes fresh PU foam contamination without residue, e.g. on windows and doors

500 ml can is adapted to PU foam guns

  • Removes fresh PU foam contamination without residue, e.g. on windows and doors

  • Contains an additional spray head for external cleaning of foam guns and other surfaces.

Can etch surfaces such as lacquer, paint and plastics. Can cause colour fading or dissolving in textiles. Hardened PU foam can only be removed with PURLOGIC foam cleaner, art. no. 0892 160 000, or mechanically.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue(X)

Catalogue page as PDF 1  |  2  |  3  |  4

Flip catalog


Safety data sheet

Application area

For cleaning fresh splashes of PU foam on surfaces such as wood, metals and clothing. Ideally suited to cleaning the gun adapter basket.


First remove the black cap. Screw the PURlogic Clean can all the way into the gun support – do not screw too far or tilt. Let the cleaner take affect inside the gun for approx. 1 to 2 minutes; then let the cleaner drain out into a suitable container (e.g. carton) through the opening in the gun tip until the cleaner runs clear. If necessary, repeat this process two or three times. Once the cleaning process is complete, remove the gun from the cleaner can. The gun can then be stored depressurised.

To clean the exterior of the foam guns or other surfaces, clip the red spray head onto the can.

Chemical basis





0.78 g/cm³

Density conditions

at 20°C










150 ml

Weight of content

117 g


Aerosol can

Shelf life from production

12 Month

Suitable glove:

Chemical protective glove, natural latex and neoprene
Chemical protective glove, natural latex and neoprene
Permeation level: 1
Cotton flocking on the inside
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
≥ 10 min
≥ 30 min
≥ 60 min
≥ 120 min
≥ 240 min
≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.
Art.-no. Cust. Mat. No.

Hazardous Material

Product information

Würth Catalogue

Catalogue page as PDF  | 

Flip catalog


Datasheets ()

CAD Data  | 




Technical information