Wall connector/flat tie rod, A4 stainless steel
MNCON-V4A-300X15X0,5
Prices for customers after login
Register now and access more than 125,000 products
Only approved for horizontal installation.
It is essential to observe the information on calculation and processing found in the approval.
Technical approval Z-17.1-711
Würth Catalogue(X)
Datasheets(X)
For connecting masonry walls using the butt joint method
Masonry connectors must be embedded completely in the joint. To ensure this, insert the connector halfway up the joint and cover the top with mortar
Minimum joint thickness 2 mm (for masonry constructed using the thin bed method)
Install perpendicular between the end faces of the walls being connected
Butt joints between walls running at different angles must always have mortar applied across the entire thickness of the wall
Minimum bond length: 140 mm
Material | Stainless steel |
Surface | Anodised |
Length | 300 mm |
Width | 15 mm |
Thickness | 0.5 mm |
Type description | MV-III |
Colour | Stainless steel coloured |