Power spray adhesive Plus
Prices for customers after login
Register now and access more than 125,000 products
Very high heat resistance up to 110°C
Permanently strong hold in different applications
Shorter process time, because material is rapidly available for further processing
2x adjustable spray head
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products. Please observe the technical data sheet!
Suitable for gluing fabric, polyether/polyester foam, foam rubber profiles, insulation materials, roof lining material, felt, cardboard (together or onto rubber), aluminium, stainless steel, copper, brass, steel/iron, ABS, GFRP, rubber/foam rubber, hard foams, polycarbonate, PU, wood (MDF, chipboards), laminated panels (Resopal, Ultrapas), cork, HPL, leather (depending on fat content) etc. Also suitable for gluing PE film (e.g. as sheeting for spray water protection inside car doors). This spray adhesive can also be used for finishing purposes and for linings (car roof linings).
Thoroughly clean surfaces to be adhered and then spray them. For absorbent and/or textured substrates/surfaces the amount of adhesive applied must be increased accordingly, i.e. the whole surface sprayed until saturated. The spray distance must be approx. 15 to 25 cm. Before joining the surfaces to be adhered to one another, allow the adhesive to flash off for 5 to 15 minutes (depending on the material and application). Use your knuckles to test whether the adhesive no longer lets off a thread at the thickest point of its application. The open time is approx. 45 minutes (depending on the ambient temperature).
Sufficient pressing force is essential to ensure positive adhesion. Tension-free bonding can be used immediately. Excess adhesive residues can be removed with acetone cleaner.
Synthetic natural rubber
Min./max. processing temperature
0 to 30 °C
Min./max. temperature resistance
-20 to 110 °C
Min. flashing point
Min./max. flash-off time
5 min-15 min
Min./max. spraying distance
Weight of content
Shelf life from production
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!