Textured acrylic
ACRYSEAL-FLEX-STRUCTURE-WHITE-310ML
Prices for customers after login
In : currently piece / pieces available
Register now and access more than 125,000 products
Fine-grain texture
An even grain texture is produced by adding high-quality quartz sand.
Can be painted over
Can be painted over with emulsion paints
Resistant to UV and ageing
Odourless
Attention:
Due to the wide variety of paint and lacquer formulas available, we recommend that you always carry out preliminary testing in order to rule out any interactions. Caution: Sealant joints that have been fully painted over tend to crack when movement occurs in the joint, as the applied paint is generally less elastic than the sealant.
Not suitable for bitumen, civil engineering and underwater joining, on silicate substrates or joints that can be walked or driven on.
Tested in accordance with EN 15651 Part 1
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
Certificates/Documents(X)
For sealing joints and cracks on indoor and outdoor structured or textured plaster. Typical surfaces: Plaster, concrete, masonry, gypsum, artificial stone, polystyrene etc.
Adhesion surfaces must be clean, dry and firm. Priming improves adhesion to porous and highly absorbent substrates. Mixing ratio of primer: Textured acrylic with water, ratio of 1:1 to 1:5 (depending on viscosity). Old coatings, mortar and cement residues must be removed. Risk of yellowing on contact with white alkyd resin paints cannot be excluded. Risk of corrosion when used on plain iron and non-ferrous metals.
Please observe the "General Notes on Application for Sealants" and "Construction Material Compatibility of Würth Sealants" overview sheet.
Container | Cartridge |
Contents | 310 ml |
Fungicidal properties | No |
Colour | White |
Chemical basis | Acrylate dispersion |
Density | 1.8 g/cm³ |
Continuous motion absorption | 5 % |
Smell/fragrance | Odourless |
Full curing speed | 0.5 mm/d |
Fully hardening/curing conditions | 23°C and 50% relative humidity |
Min. skin-formation time | 5 min |
Min. breaking elongation | 50 % |
Breaking elongation conditions | for 2-mm film |
Conditions for skin-formation time | at 23°C and 50% relative humidity |
Shore A hardness | 28 |
Min./max. temperature resistance | -20 to 75 °C |
Min./max. processing temperature | 5 to 40 °C |
Recoatable/Can be painted over | Yes |
Surface pre-treatment required | On absorbent or porous surfaces |
Ratio of ingredients | Mixing ratio of acrylic sealant to water = 1:1 to 1:5 |
Ultraviolet resistance | Yes |
Coating compatibility | Yes |
Shelf life from production | 18 Month |
Conditions to maintain shelf life from production | at 10°C to 25°C |